Parent container
Posted: Sat Nov 18, 2017 10:01 pm
I've installed a CRU cinema drive into my workstation to facilitate easier film transfers to the DCP projector.
What I'm doing is copying just the Filmname_FTR_... directory to the CRU drive.
However, when it comes time to injest into the projector, we need to open each directory on the drive and select the film and then select import import.
Normally, when the theater gets films, they just open a single parent directory and can then just click down the list to select all the films and do a single import.
What I'm trying to understand is how to replicate this same process as we have many films to import and opening separate directories is quite time consuming.
I hope I described the problem properly.
JIm
What I'm doing is copying just the Filmname_FTR_... directory to the CRU drive.
However, when it comes time to injest into the projector, we need to open each directory on the drive and select the film and then select import import.
Normally, when the theater gets films, they just open a single parent directory and can then just click down the list to select all the films and do a single import.
What I'm trying to understand is how to replicate this same process as we have many films to import and opening separate directories is quite time consuming.
I hope I described the problem properly.
JIm